Alesis iMultiMix 16 USB Especificaciones descargar pdf (Pagina 33)

Troubleshooting

5

31

Effects processor is not plugged

in or turned on.

Make sure unit is plugged in and

turned on.

A

ux outputs of mixer aren’t

connected to inputs of processor

or processor’s outputs aren’t

connected to mixer’s inputs.

Make sure the mixer’s aux outputs

are connected to the processor’s

inputs and that the processor’s

outputs are connected to the mixer’s

aux inputs.

External effects aren’t working.

Mixer’s effects return signal is

too low.

Turn up the output of the effects

processor or turn up the mixer’s

A

UX RET A RETURN or

EFFECTS / AUX RET B

RETURN in the master section.

LED meters not working.

Nothing is routed to the

HDPH/CTRL RM output.

Press the desired MIX, ALT ¾ or 2

TK button.

Computer does not see the

iMultiMix

USB.

USB connection must be

established.

Unplug the USB cable and turn off

the iMultiMix

USB. Turn the

iMultiMix

USB back on and plug

the cable back in. If this does not

w

ork, leave the iMultiMix USB on,

turn off the computer (do not use

“restart” but instead actually turn of

f

the computer) and then turn it on

again.

Computer sees the iMultiMix

USB, but no sound is received

and/or transmitted.

iMultiMix USB is not set as

primary sound device.

In the computer’s Control Panel, go

to the Sounds/Multimedia area. In

the Audio section, set the default

sound recording and playback

devices to “USB audio codec.”

USB hub may be in use.

.

USB audio has crackling or

glitches, or audio plays/records at

incorrect pitch.

Computer configuration may be

incompatible with USB audio

If you are using a USB hub,

disconnect the iMultiMix

USB

from it and connect the mixer to the

computer directly instead. Certain

USB chipsets have design limitations

or IRQ assignment restrictions that

must be resolved before audio can

w

ork correctly on them. See your

USB chipset documentation for

further information if required.

No power.

Incorrect or defective power

supply.

Replace with correct power supply

(only use Alesis-recommended AC

output power supply).

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 43 44

Comentarios a estos manuales

Sin comentarios